11
Panel Descriptions
3. PEAK indicators
Light up when level of the input signal is too high. Use the [INPUT 1 (MIC)], [INPUT 2 (GUITAR)], and
[INPUT 3 (AUX)] knobs to adjust the input level so that a PEAK indicator does not light.
4. SIG indicators
The corresponding indicator lights up when an audio signal is input via the INPUT 1 (MIC), INPUT 2
(GUITAR), or INPUT 3 (AUX) jack.
5. [INPUT 1 (MIC)] knob, [INPUT 2 (GUITAR)] knob, [INPUT 3 (AUX)] knob
Adjust the volume of the audio signal input via the INPUT 1 (MIC), INPUT 2 (GUITAR), or INPUT 3
(AUX) jack(s).
The input volume will not be set to zero even if the [INPUT 1 (MIC)] knob is turned fully to the left.
The input volume is set to zero if the [INPUT 2 (GUITAR)] or [INPUT 3 (AUX)] knob is turned fully to the
left.
6. [REC MODE] button
The TRI-CAPTURE has three recording modes. You can change the recording mode by pressing this
button (p. 23).
7. [INPUT MONITOR] button
Sets whether to directly output the
input signal.
When the [INPUT MONITOR] button
is set to “ON,” you can listen to the
instrument’s output directly without
passing the audio signal through the
computer.
When the [INPUT MONITOR] button
is set to “OFF,” the instrument’s audio
signal passes through the computer,
therefore the sound may be delayed.
When ASIO 2.0-compatible software is
used, the ASIO Direct Monitor setting
determines this setting.
8. [OUTPUT MUTE] button
Switches on or o output of the audio signal from the OUTPUT jack.
The audio signal is output from the PHONES jack regardless of the [OUTPUT MUTE] button setting.
9. Output level indicators
Indicate the output volume. The output level indicators work regardless of the [OUTPUT MUTE]
button’s setting.
[INPUT MONITOR] button
OFF
+
+
ON
INPUT 1 (MIC)
INPUT 2 (GUITAR)
INPUT 3 (AUX)
OUTPUT
PHONES
To Next Page
Loading...
