Roland TRI-Capture - Playing Back

22
How to Use
Playing Back
Connect the TRI-CAPTURE to a computer using the USB cable. Audio data is transferred in both
directions between the TRI-CAPTURE and computer via the USB cable.
By connecting headphones or amplied speakers as shown in the illustration, you can monitor
playback from your DAW software or the sound from an instrument or audio device connected to
the TRI-CAPTURE.
Computer
Amplied speakersHeadphones
Audio output device of
software: TRI-CAPTURE
Rear panel
Set the [OUTPUT
MUTE] button
to ”ON” to
not output
sound from the
speakers.
Use the
[PHONES] knob
to adjust the
volume of the
headphones.
Front panel
* To carry out playback at a sampling rate of 96 kHz, set the [SAMPLE RATE] switch on the bottom
panel to “96k,” and set the [MODE] switch on the bottom panel to “PLAY.”