21
How to Use
This section explains the basic connections and settings for the TRI-CAPTURE.
Refer also to the block diagrams (p. 48).
Precautions Concerning the Use of Software
Before using any software, please note the following points.
• Connect the TRI-CAPTURE to the computer before starting the software.
• Do not disconnect the TRI-CAPTURE from the computer while the software is running. After
exiting the software, disconnect the TRI-CAPTURE.
• Select the TRI-CAPTURE for your software’s audio device setting.
• Match the sampling rate of the software to the setting of the [SAMPLE RATE] switch on the
bottom panel.
• The TRI-CAPTURE will not operate in the Mac OS X Classic environment. Use the TRI-CAPTURE
when the Classic environment is not running.
Input/Output Device Settings
To play and record audio data on your software, select the TRI-CAPTURE as the audio input/output
device. For details about settings, refer to the documentation for your software.
Audio Output Device
Device name MME, WDM/KS ASIO Core Audio
TRI-CAPTURE OUT (TRI-CAPTURE) OUT 1-2 1, 2
Audio Input Device
Device name MME, WDM/KS ASIO Core Audio
TRI-CAPTURE IN (TRI-CAPTURE) IN 1-2 1, 2
To Next Page
Loading...
