3. Assembly and Ink Filling
9
I
Place the printer unit on the stand, and lightly tighten its bolts in the order of
1
,
2
.
Set the assembled stand upright, and then x the printer unit to it by tightening the bolts (8 locations in
total). Use a washer for each bolt.
Tighten
temporarily
Bolts: 8
Washers: 8
J
Fully tighten the bolts in the order of
1
,
2
.
Tighten the bolts securely. Loose bolts may cause the stand to wobble.
Tighten fully
Bolts: 8
Washers: 8
To Next Page
Loading...
