18
Connecting External Equipment
3. Enable the input.
Turn the [VALUE] dial to change the enabled connector.
g.select-VIDEO.eps
You can also change the enabled connector using the [VIDEO] button and the input selector buttons of A-Bus. Hold down the [VIDEO] button and
press the input selector of the channel you want to change the enabled connector. On channels 1 through 3, switching alternates between HDMI
and composite. Channel 4 is switched in this sequence of : composite -> S-Video -> HDMI -> RGB/component.
Connecting Audio Source Equipment
Connect an audio mixer or other source device to the AUDIO IN connectors. Input made via these connectors is output from the
HDMI connectors and the USB port together with the results of video mixing (embedded audio).
* When connection cables with resistors are used, the volume level of equipment connected to the inputs (AUDIO IN) may be low. If this happens,
use connection cables that do not contain resistors.
g.audio-connection.eps
Audio Mixer
Use the menus to adjust the balance/volume of the audio output (p. 36) or delay its timing to sync with the video (p. 37).
To Next Page
Loading...
