Roland V-combo VR-09 - Selecting Piano Sounds; Selecting Synthesizer Sounds

Selecting Sounds
13
Selecting Piano Sounds
1. Press the MODE [PIANO] button.
The MODE [PIANO] button will light.
Volume
(PIANO LEVEL
[ ] [ ] button)
Octave (p. 26)
Sound
Sound variation
Multi-eect type (p. 44)
MEMO
Use the CURSOR [
] [ ] buttons to move the cursor to an item,
and turn the [VALUE] dial to change the sound variation/multi-
eect type.
Selecting the piano sound variation
1. Press one of the sound buttons in the piano section.
The sound variation select screen appears.
2. Turn the [VALUE] dial to select the desired sound
variation.
MEMO
• You can play the keyboard to audition the sound at which the
cursor is located.
• If you press the [TRANSPOSE] button while the sound variation
select screen is shown, the select screen will be held. Press the
[EXIT] button to return to the previous screen.
Selecting Synthesizer Sounds
1. Press the MODE [SYNTH] button.
The MODE [SYNTH] button will light.
Volume
(SYNTH LEVEL [ ] [ ] button)
Octave (p. 26)
Sound
Sound variation
Multi-eect type (p. 44)
MEMO
Use the CURSOR [
] [ ] buttons to move the cursor to an item,
and turn the [VALUE] dial to change the sound variation/multi-
eect type.
Selecting the Synthesizer sound variation
1. Press one of the sound buttons in the synthesizer section.
The sound variation select screen appears.
2. Turn the [VALUE] dial to select the desired sound
variation.
MEMO
• You can play the keyboard to audition the sound at which the
cursor is located.
• If you press the [TRANSPOSE] button while the sound variation
select screen is shown, the select screen will be held. Press the
[EXIT] button to return to the previous screen.
Introduction Performing Recording Looper Settings
Appendix