Roland V-combo VR-09 - Loading Saved Registrations from a USB Flash Drive (Load Registration); Deleting Saved Registrations from a USB Flash Drive (Delete Registration)

Convenient Functions
40
Loading Saved Registrations from a
USB Flash Drive (Load Registration)
Here’s how a registration set saved on a USB ash drive can be
loaded into the VR-09.
NOTE
When you load a registration set, all registrations stored in the
VR-09 will be overwritten and lost. If you don’t want to lose
these registrations, save them to a USB ash drive (p. 39).
1. Connect a USB ash drive (sold separately) to the USB
MEMORY port (p. 6).
2. Press the [MENU] button.
3. Turn the [VALUE] dial to select “Media Utility.”
4. Press the [ENTER] button.
5. Use the CURSOR [
] [ ] buttons to select “Load
Registration.”
6. Press the [ENTER] button.
The LOAD REGISTRATION screen appears.
7. Turn the [VALUE] dial to select the registration set you
want to load.
If you decide to cancel, press the [EXIT] button.
8. Press the [ENTER] button.
The registration set will be loaded.
NOTE
Do NOT turn o the power or disconnect the USB ash drive
while “Executing...” is displayed.
9. Press the [EXIT] button several times to nish the
procedure.
Deleting Saved Registrations from a
USB Flash Drive (Delete Registration)
Here’s how a registration set saved on a USB ash drive can be
deleted into the VR-09.
1. Connect a USB ash drive (sold separately) to the USB
MEMORY port (p. 6).
2. Press the [MENU] button.
3. Turn the [VALUE] dial to select “Media Utility.”
4. Press the [ENTER] button.
5. Use the CURSOR [
] [ ] buttons to select “Delete
Registration.”
6. Press the [ENTER] button.
The DELETE REGISTRATION screen appears.
7. Turn the [VALUE] dial to select the registration set you
want to delete.
8. Press the [ENTER] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
9. Press the [ENTER] button.
The registration set will be deleted.
NOTE
Do NOT turn o the power or disconnect the USB ash drive
while “Executing...” is displayed.
10. Press the [EXIT] button several times to nish the
procedure.