Recording Your Performance
34
8. Press the [ENTER] button or the MODE [SYNTH] (Save)
button.
The song will be saved.
* If you recorded in audio format and an identically-named song
exists on the USB ash drive, you won’t be able to save.
If the following screen appears, press the [ENTER] button and
assign a dierent name.
NOTE
Do NOT turn o the power or disconnect the USB ash drive
while “Executing...” is displayed.
Playing a Song
Here’s how to play back a song that you’ve saved on a USB ash
drive.
1. Connect a USB ash drive (sold separately) to the USB
MEMORY port (p. 6).
2. Press the [SONG/RHYTHM] button several times to access
the SONG screen.
3. Turn the [VALUE] dial to select the song.
MEMO
If you wish to select a song stored in a folder on a USB ash
drive, you can navigate as follows.
• To move to a dierent folder: Use the [VALUE] dial to select the
“
,” and then press the [ENTER] button or the [ ]
(START/STOP) button.
• To select a song within the folder: Use the [VALUE] dial.
• To move out of a folder: Use the [VALUE] dial to select the
“
,” and then press the [ENTER] button or the [ ]
(START/STOP) button.
4. Press the [
] (START/STOP) button.
The song will start playing.
The measure number is displayed for SMF-format songs, and the
playback time is displayed for audio-format songs.
5. Press the [ ] (START/STOP) button.
The song will stop playing.
MEMO
• You can change the playback tempo of SMF format songs (p. 32).
• You can use the DRUM LEVEL [
] [ ] buttons to adjust the
playback volume (p. 32).
• If the song was recorded on the VR-09 as SMF data, you can use
the LEVEL [
] [ ] buttons of each section or the [LEVEL] bar to
adjust the volume.
Button operations
[ ] button
Returns to the beginning of the song. If you press
this at the beginning of a song, you’ll move to the
beginning of the preceding song.
Hold down the button to rewind the song.
[
] button
Moves to the next song. Hold down the button to
fast-forward the song.
[
] (START/STOP)
button
Play/stop the song.
To Next Page
Loading...
