Roland V-Drums TD-27 - Recording Your Performance; Recording a Performance; Saving Recorded Performances; Recording Performance with a Song

18
KIT EDIT
MASTER EQ
Here you can adjust the overall tonal character of the entire drum kit. You can use four bands (LOW/MID1/MID2/HIGH) of boost/cut to adjust the
sound. This can also be used to compensate the tonal character when using the master compressor.
You can adjust the equalizer’s eect (shelving and peaking) for the low frequency (LOW) and high frequency (HIGH).
The master EQ is output from the MASTER OUT jacks and PHONES jack.
This indicates whether the master EQ eect is output ( ) from each
jack or is not output (
).
MST: MASTER OUT jacks
PHO: PHONES jack (always output)
Parameter Value Explanation
Type
SHELV (Shelving),
PEAK (MID1 and MID2: xed to “PEAK”)
Type of equalizer
Q
0.5–8.0 (only when Type is set to “PEAK”)
Width of the frequency range
A higher Q narrows the aected area.
Freq
20Hz–1kHz (LOW)
20Hz–16kHz (MID1, 2)
1kHz–16kHz (HIGH)
Center frequency
Gain
-12–+12dB Amount of boost/cut
[F1] button (OFF, MST EQ ON)
OFF, MST EQ ON Turns master EQ on/o.
* If the routing setting (p. 36) Master Out is set to “DIRECT,” the eect of the master EQ does not apply to the sound that is output from the MASTER OUT jacks.