Roland V-Drums TD-27 - Flanger; Phaser a; Phaser B; Step Phaser

45
Multi-Eect Parameters
PHASER A
A phase-shifted sound is added to the original sound and modulated.
Parameter Value Explanation
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the phaser
Manual
0–127
Adjusts the basic frequency from which the
sound will be modulated.
Tempo Sync
OFF, ON
Species whether the modulation rate is
specied as a note value (ON) or not (OFF).
Rate
0.05–10.00Hz,
note
Frequency of modulation
Depth
0–127 Depth of modulation
Polarity
INVERSE,
SYNCHRO
Selects whether the left and right phase
of the modulation will be the same or the
opposite.
INVERSE: The left and right phase will be
opposite. When using a mono source, this
spreads the sound.
SYNCHRO: The left and right phase will be
the same. Select this when inputting a stereo
source.
Resonance
0–127 Amount of feedback
Cross
Feedback
-98–+98%
Adjusts the proportion of the phaser sound
that is fed back into the eect. Negative “-”
settings will invert the phase.
Low Gain
-15–+15dB Gain of the low range
High Gain
-15–+15dB Gain of the high range
Level
0–127 Output Level
PHASER B
This simulates a dierent analog phaser than Phaser A.
Parameter Value Explanation
Speed
0–100 Frequency of modulation
Depth
0–127 Depth of modulation
Low Gain
-15–+15dB Gain of the low range
High Gain
-15–+15dB Gain of the high range
Level
0–127 Output Level
STEP PHASER
The phaser eect will be varied gradually.
Parameter Value Explanation
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the phaser
Manual
0–127
Adjusts the basic frequency from which the
sound will be modulated.
Tempo Sync
(Rate)
OFF, ON
Species whether the modulation rate is
specied as a note value (ON) or not (OFF).
Rate
0.05–10.00Hz,
note
Frequency of modulation
Depth
0–127 Depth of modulation
Polarity
INVERSE,
SYNCHRO
Selects whether the left and right phase
of the modulation will be the same or the
opposite.
INVERSE: The left and right phase will be
opposite. When using a mono source, this
spreads the sound.
SYNCHRO: The left and right phase will be
the same. Select this when inputting a stereo
source.
Resonance
0–127 Amount of feedback
Cross
Feedback
-98–+98%
Adjusts the proportion of the phaser sound
that is fed back into the eect. Negative “-”
settings will invert the phase.
Tempo Sync
(Step Rate)
OFF, ON
Species whether the modulation rate of the
phaser eect is specied as a note value (ON)
or not (OFF).
Step Rate
0.10–20.00Hz,
note
Rate of the step-wise change in the phaser
eect
Low Gain
-15–+15dB Gain of the low range
High Gain
-15–+15dB Gain of the high range
Level
0–127 Output Level
FLANGER
This is a stereo anger. (The LFO has the same phase for left and
right.) It produces a metallic resonance that rises and falls like a jet
airplane taking o or landing. A lter is provided so that you can
adjust the timbre of the anged sound.
Parameter Value Explanation
Filter Type
OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above the
Cuto Freq
HPF: cuts the frequency range below the
Cuto Freq
Cuto Freq
200–8000Hz
Species the frequency at which the lter
cuts a specic frequency region
Pre Delay
0.0–100.0ms
Adjusts the delay time from when the direct
sound begins until the anger sound is
heard.
Tempo Sync
OFF, ON
Species whether the modulation rate is
specied as a note value (ON) or not (OFF).
Rate
0.05–10.00Hz,
note
Frequency of modulation
Depth
0–127 Depth of modulation
Phase
0–180deg Spatial spread of the sound
Feedback
-98–+98%
Adjusts the proportion of the anger sound
that is fed back into the eect. Negative “-”
settings will invert the phase.
Low Gain
-15–+15dB Gain of the low range
High Gain
-15–+15dB Gain of the high range
Level
0–127 Output Level