Roland V-Synth GT Supplementary Manual

8
List of Added Tone-FX
48: Slicer
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played
as a backing phrase. This is especially effective when applied
to sustain-type sounds.
fig.MFX-20
49: VK Rotary
This type provides modified response for the rotary speaker,
with the low end boosted further.
This effect features the same specifications as the VK-7’s
built-in rotary speaker.
fig.MFX-22
Parameter
Value Description
Step 01–16 0–127 Level at each step
Rate #1
0.05–10.00 Hz,
note
Rate at which the 16-step sequence
will cycle
Attack 0–127
Speed at which the level changes
between steps
Input Sync Sw OFF, ON
Specifies whether an input note will
cause the sequence to resume from
the first step of the sequence (ON) or
not (OFF)
Input Sync
Threshold
0–127
Volume at which an input note will be
detected
Mode
LEGATO,
SLASH
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO: The change in volume from
one step’s level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH: The level is momentarily set
to 0 before progressing to the level of
the next step. This change in volume
occurs even if the level of the following
step is the same as the preceding step.
Shuffle #2 0–127
Timing of volume changes in levels for
even-numbered steps (step 2, step 4,
step 6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output level
L in
R in
L out
R out
Slicer
Slicer
Parameter
Value Description
Speed #1
SLOW, FAST
Rotational speed of the rotating
speaker
Brake #2 OFF, ON
Switches the rotation of the rotary
speaker.
When this is turned on, the rotation
will gradually stop. When it is turned
off, the rotation will gradually resume.
Woofer Slow
Speed
0.05–10.00 Hz
Low-speed rotation speed of the
woofer
Woofer Fast
Speed
0.05–10.00 Hz
High-speed rotation speed of the
woofer
Woofer Trans Up 0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Slow to Fast.
Woofer Trans
Down
0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Fast to Slow.
Woofer Level 0–127 Volume of the woofer
Tweeter Slow
Speed
0.05–10.00 Hz
Settings of the tweeter
The parameters are the same as for the
woofer.
Tweeter Fast
Speed
0.05–10.00 Hz
Tweeter Trans Up 0–127
Tweeter Trans
Down
0–127
Tweeter Level 0–127
Spread 0–10
Sets the rotary speaker stereo image.
The higher the value set, the wider the
sound is spread out.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Level #3 0–127 Output Level
Speaker Type
STANDARD,
STACK, CLEAN
Type of speaker
L out
R out
L in
R in
Rotary
2-Band EQ
2-Band EQ
V-Synth_GT_v2_e1.book 8 ページ ２００８年１２月１７日 水曜日 午前９時５分

Roland V-Synth GT Specifications

General

Brand	Roland
Model	V-Synth GT
Category	Synthesizer
Language	English