Activate oscillator 2, touch the OSC2 pad and the Pitch tab . Change Fine to +5
so that the oscillators slowly “beat” against each other. With two oscillators the sound is
now much thicker, but pushing the Bender only adds vibrato to oscillator 1 at the
moment. Go back to the Common / Matrix Ctrl page and select the Control 3/4 tab
. Set the same values in Control 3 as in Control 1, but for oscillator 2 instead:
Source = CC01
Destination1 = 040:OSC2-LFO-PCH
Sens = +14
Destination2 = 39:OSC2-LFO-RATE
Sens = +2
Play the keyboard and push the Bender. You should be able to hear that the LFOs in both
oscillators have the same rate, but also that they are not synchronized - one can start
later (in it’s cycle) than the other. To remedy this, go to each of the oscillator LFO pages
in turn and switch on Key Sync.
Now let’s create a control for the amount of Reverb. Select KNOB1 as Control 4 source
, set Destination1 to 075:REV-SEND and sensitivity to +63. Even if you turn
up the C1 knob now, you won’t hear any reverb because it hasn’t been switched on yet.
Touch the Effect pad (and the Routing tab if necessary) then set Reverb Type to
06 (Hall3) . Save your refined version of “Simplicity”!
To Next Page
Loading...
Need help?
General
