The initial patch already reacts quite
strongly to keyboard velocity, and this is
seldom desirable when creating new
patches. Touch the TVA pad , then the
Velocity Curve control . Press the
DEC/- button (below the VALUE dial) to
change the curve to 0 (flat). Open the
dropdown menu again and select PATCH
Write . Touch the Execute pad in
the PATCH Write window.
✱
YYoouu wwiillll nneeeedd tthhiiss
“
vvaanniillllaa”” ppaattcchh
tthhrroouugghhoouutt tthhee ttuuttoorriiaall......
...so why not put it in the PATCH
PALETTE for instant recall? Hold down
the PATCH ASSIGN button and
press 8 . To find INIT PATCH, just
press button number 8 from now on.
The following instructions may seem rather long and needlessly detailed, but there is a very good reason for this – it has to be assumed
that you know absolutely nothing about the V-Synth architecture or menu structure at this stage. Please take your time and try to be
aware of the reason for everything you are asked to do. After you have become more familiar with the programming environment, creating
such a basic patch should only take a minute or two.
The Simplest of Patches
INIT PATCH
In PATCH PLAY mode, use the VALUE dial to select patch number 512 – the highest
one available . Holding down the SHIFT button at the same time will scroll through
patch numbers in steps of 10, so this is of course the best method. Touch the triangle in
the top right-hand corner of the screen, select PATCH Init from the dropdown menu
, then touch the EXECUTE pad in the bottom right-hand corner of the screen . If
you find you have selected a different function by mistake (e.g. PATCH Write or PATCH
Copy), simply touch the CANCEL pad or press the EXIT button, and try again.
Tip: When calling functions from the drop-down menu, you may find it easier to do this
all at once: Touch the triangle and don’t release immediately. Drag your finger down until
the function you want is highlighted – then release!
To Next Page
Loading...
Need help?
General
