Roland VC-1-SC - Side Panel Description

Panel Descriptions
15
Side Panel
3 4 51 2
1. USB port
Connect a computer used for remote control (p. 24).
* Operating the VC-1-SC by remote control requires downloading of the dedicated software
(VC-1 RCS) and installing it on a computer. You can download the dedicated software from the
following Roland website.
http://www.rolandsystemsgroup.net/
2. INPUT SELECT switch
Each press switches the input connector. Refer to “Setting the Operation Mode” (p. 25).
* If the switch is dicult to press, use the tip of a pen or other narrow object to press it.
3. SCALING TYPE switch
Each press changes the screen aspect (scaling). Refer to “Setting the Operation Mode” (p. 25).
* If the switch is dicult to press, use the tip of a pen or other narrow object to press it.
4. Mode switches (MODE SW)
These set the VC-1-SC’s operation mode. Refer to “Setting the Operation Mode” (p. 25).
* Use the tip of a pen or similar object to change the setting of a switch.
5. Cord hook
Use this to secure the AC Adaptor cord in place. Refer to “About Securing the Power Cord” (p. 11).