Switching the Ink
16
ECO-SOL MAX 3 Ink Switching Method
3.
Reconnect a printer that has been switched to MAX 3 ink to VersaWorks.
Start VersaWorks.
The [Printer Settings] screen will appear.
Set [IP Address] to the IP address of the printer that has been switched to MAX 3 ink.
Click [Verify].
Check that [Ink Type] is the MAX 3 ink.
This indicates that you have successfully reconnect-
ed to a printer that has been switched to MAX 3 ink.
Click [Apply].
The printer that has been switched to MAX 3 ink is
displayed under [Printer List].
If there are multiple printers that have been switched to MAX 3 ink, click .
Repeat steps
,
,
, and
to reconnect to these printers that have been switched to MAX 3 ink.
Click [OK].
This completes the operations to switch to MAX 3 ink.
To Next Page
Loading...
