Roland VersaStudio BN-20 - STEP 10: Updating Versaworks

Switching the Ink
15
ECO-SOL MAX 3 Ink Switching Method
STEP 10: Updating VersaWorks
1. Update VersaWorks.

Refer to http://www.rolanddg.com/ecosolmax3/ and update VersaWorks to a version that supports
MAX 3 ink.

If VersaWorks is running, exit it.
When only a printer that has been switched to MAX 3 ink is connected to VersaWorks
2. Initialize VersaWorks.

Windows 8.1
Click on the [Start] screen.
Click [Initialize Application] for Roland VersaWorks.
Windows 8
Right-click in the [Start] screen.
Click [All apps].
Click [Initialize Application] for Roland VersaWorks.
Windows Vista/7
Click the [Start] ( ) menu.
Click [All Programs] (or [Programs]) > [Roland VersaWorks] > [Initialize Application].

When the screen shown in the gure is
displayed, click [Yes].
From this point, the procedure differs depending on the type of printer that is connected
to VersaWorks.
When only a printer that has been switched to MAX 3 ink is connected to VersaWorks (P. 15 )
Initialize VersaWorks, and then reconnect the printer to it as a new printer. All the information will be deleted
due to the initialization. We recommend that you write down the IP address of the printer that you will
reconnect and the settings of the VersaWorks application that you want to continue to use.
When a printer that does not use MAX 3 ink is connected to VersaWorks (P. 17 )
Leave the printer that does not use MAX 3 ink connected (leave the information set in VersaWorks). Only
reconnect the printer that has been switched to MAX 3 ink as a new printer. All the information of the newly
reconnected printer is deleted (the information of the printer that does not use MAX 3 ink remains), so we
recommend that you write down the IP address of the printer that has been switched to MAX 3 ink and the
settings of the VersaWorks application that you want to continue to use.