7
Parameter List
Parameter
Value Explanation
Motif
Sets the order in which notes of the chord will sound.
UP
Notes you press will be sounded, from low to
high.
DOWN
Notes you press will be sounded, from high
to low.
UP&DOWN
Notes you press will be sounded, from low to
high, and then back down from high to low.
RANDOM
Notes you press will be sounded, in random
order.
NOTE_ORDER
Notes you press will be sounded in the order
in which you pressed them. By pressing
the notes in the appropriate order you can
produce melody lines. Up to 128 notes will be
remembered.
GLISSANDO
Each chromatic step between the highest
and lowest notes you press will sound in
succession, repeating upward and downward.
Press only the lowest and the highest notes.
CHORD All notes you press will sound simultaneously.
AUTO1
The timing at which keys will sound will be
assigned automatically, giving priority to the
lowest key that was pressed.
AUTO2
The timing at which keys will sound will be
assigned automatically, giving priority to the
highest key that was pressed.
PHRASE
Pressing a single key will sound the phrase
based on the pitch of that key. If multiple
keys are pressed, the last-pressed key will be
valid.
Hold OFF, ON Turn the hold function on/o.
Velocity
REAL,
1–127
Species the loudness of the notes that you
play. If you want the velocity value of each
note to depend on how strongly you play
the keyboard, set this parameter to “REAL”. If
you want each note to have a xed velocity
regardless of how strongly you play the
keyboard, set this parameter to the desired
value (1–127).
Oct Range -3–+3
Sets the key range in octaves over which
arpeggio will take place. If you want the
arpeggio to sound using only the notes that
you actually play, set this parameter to “0”.
To have the arpeggio sound using the notes
you play and notes 1 octave higher, set this
parameter to “+1”. A setting of “-1” will make
the arpeggio sound using the notes you play
and notes 1 octave lower.
Acc Rate 0–100 %
Modies the strength of accents and the
length of the notes to adjust the “groove”
feel of the arpeggio. A setting of “100 %” will
produce the most pronounced groove feel.
Sh Rate 0–100 %
This setting lets you modify the note timing
to create shue rhythms. With a setting of
“50 %” the notes will be spaced evenly. As the
value is increased, the note timing will have
more of a “dotted” (shue) feel.
50 5050 50
90 10 90 10
Shue Rate = 50 %
Shue Rate = 90 %
Sh Reso
,
Species the timing (as a note value) at which
the notes will be heard.
The note value can be specied as either a
sixteenth note or an eighth note.
Chord Mode OFF, ON
When this is on, the pads play arpeggios even
in Chord mode.
VOCAL COMP
Parameter Value Explanation
Switch
OFF, ON Compressor on/o
Attack
0.1–100 [ms]
Time from when the input exceeds the
threshold until compression begins
Release
10–1000 [ms]
Time from when the input falls below the
threshold until compression is turned o
Thres
-60–0 [dB] Level at which compression is applied
Ratio
1: 1–inf: 1 Compression ratio
Knee
0–30 [dB]
This is a function that smooths the onset of
compression from the uncompressed state; it
gradually applies compression starting earlier
than Threshold. Higher values produce a
smoother transition.
Gain
-24–+24 [dB] Level of the output sound
Out Asgn DRY, MFX Species the compressor output destination.
To Next Page
Loading...
Need help?
General
