Bread slicer C42 – C42S – C52 – C52S – G42
(Original instructions) – Edit. 02/2013 – Rev.A
3.3
ELECTRICAL CONNECTIONS
All work of an electrical nature in the place of use must be performed only by personnel with specific
technical and professional qualifications and possessing the necessary technical and legal knowledge
to carry out the work properly and in compliance with the regulations in force, considering also the
type of premises, and authorised to issue any declaration of conformity contemplated by the law.
On delivery of the machine and before making the electrical connection, make sure that the line
voltage supplied complies with that stipulated by the machine manufacturer and indicated on the
identification plate (see also par. 0). Connection to the electrical plant at the work site must be
performed observing the standards and legislation in force, and referring to the data and indications in
this manual.
When contemplated, the machine is delivered complete with cable and three-phase plug with earth
pin (Figure 10). The power cable must be kept far from hot parts and/or moving parts and must not
hinder or prevent the movement or passage of persons, animals, things. The power plug must
always be easily accessible (do not place the machine itself or anything else in front of the socket
where the plug is connected).
IMPORTANT! When starting up for the first time, check that the motor is turning in the
correct direction. If necessary, have a specialised technician invert two phase leads (see also
par.3.8).
EEC PLUG (3 PHASE +
PE)
Use the earth system provided, the efficiency of which must be checked,
and do not connect to gas or water pipes or any other general metal
structures.
WARNING! A device must be installed upline from the power socket
to guarantee disconnection from the mains supply, with a contact
opening distance of at least 3 mm.
Figure 10
3.4
OPERATION AND USE
WARNING!
Only one operator at a time can use the machine, without exceptions, and there must be no one
else in the vicinity.
It is forbidden for anyone without the requisites stipulated in this manual to carry out any
operation on or with the machine.
These are the conditions necessary for a safe use of the machine, even if they do not provide a
total guarantee.
The machine must be used only by personnel who have been adequately instructed and trained
and expressly authorised; it is the responsibility of the employer to identify the persons suited to use
the machine and to provide them with the necessary information, instruction and training.
The Manufacturer declines all liability for any damage to people, animals and/or property deriving
from failure to observe the instructions contained in this manual.
To use the machine for production purposes (operations of loading/unloading bread/slices and
activating the controls to slice the bread), the operator must stand in front of the machine (on
the side opposite the sharp edges of the blades).
When starting the machine for the first time and if the motor has had to be replaced, check that the
motor is turning in the correct direction, as described in par. 3.8.
3.4.1 PRECAUTIONS AND PRELIMINARY CHECKS
• Check that the wheels with brake are blocked (type C-S and support trolley for types C and G)
• Before connecting the machine plug to the power socket, make sure that there are no inflammable
and/or explosive products and/or substances in the vicinity, or appliances that use and/or produce
such substances.
To Next Page
Loading...