Rollmatic C42 - REGULATING the COMB PRESSURE (Extraordinary Maintenance); REGULATING the PUSHER PRESSURE (Extraordinary Maintenance)

Bread slicer C42 – C42S – C52 – C52S – G42
(Original instructions) – Edit. A
19
Figure 18
4.5 REGULATING THE COMB PRESSURE (extraordinary maintenance)
On models where it is contemplated, to adjust the comb pressure proceed as follows, referring to
Figure 19
1. Turn the main switch to O (OFF) and take the plug out of the power supply socket;
2. With the index finger of one hand, take the loop of the spring Figure 19 and shift it to the
second position, considering that:
Pos. 1 LESS comb pressure
Pos. 2 MORE comb pressure
Figure 19
For models equipped with a comb without the two adjustment positions, replace the spring with a
stronger one
4.6 REGULATING THE BREAD PUSHER
PRESSURE (extraordinary maintenance)
If the pressure exerted by the bread pusher is too weak or too
strong, change the position of the spring, Figure 20, which is
under the surface where the bread comes out, ref. 4 Figure 1
Figure 20