Rollmatic C42 - Residual Risks of an Electrical Nature; Information on Machine Noise Levels; Safety Signs

Bread slicer C42 – C42S – C52 – C52S – G42
(Original instructions) – Edit. 02/2013 – Rev.A
26
5.1.5 RESIDUAL RISKS OF AN ELECTRICAL NATURE
This risk is related to possible accidental contacts with live parts e.g.. during maintenance work.
WARNING! Before dismantling/opening any guards or parts, the removal of which permits
access to live (or anyway dangerous) parts, and/or before starting any operation on live voltage
parts, the technician appointed to do the job must disconnect the plug from the electrical socket
and place the removed plug in a position that is constantly in view. This is necessary so that the
technician can be sure at any moment that the machine is not electrically powered. No motives
can be reasonably foreseen why the technician should need to work on live voltage parts.
Remember that all work of an electrical nature must be performed only by expert personnel
possessing the necessary technical and legal knowledge to carry out the work properly.
5.2 INFORMATION ON MACHINE NOISE LEVELS
On the base of phonometric analyses carried out on machines which are very similar in terms of
conformation and function, and the same with regards to performance, executed with a Class 1
integrated sound level meter, with microphone on the front of the machine in correspondence with the
operator position (approximately 200 mm horizontal distance from the machine, and 1.6 m from the
floor), machines that have just left the factory, to which this manual refers, when operating without
load and in normal conditions, issue an equivalent continuous weighted sound pressure level LA
eq
lower than 70 dB(A), also considering a maximum error of + 2.0 dB(A).
5.3 SAFETY SIGNS
The safety signs shown in Figure 26 are applied on the machine in the factory
Figure 26
Check that the images and colours of the signs are in a perfect state of conservation; in the
event of deterioration, report the problem to the persons responsible and/or the manager who
will have to restore them.
FORBIDDEN: to remove
safety devices
FORBIDDEN: to clean, lubricate or adjust machine elements while they are moving
FORBIDDEN: to put your hands into the compartment of the crumb
collection drawer
DANGER: Sharp blades
DANGER: Dangerous
voltage
DANGER: Moving
mechanical parts