Bread slicer C42 – C42S – C52 – C52S – G42
(Original instructions) – Edit. A
25
WARNING! Never put your hands into the loading compartment. Risk of cutting!
Figure 23
Risk of catching, dragging and crushing due to the presence of moving parts in the case of
inserting the fingers in the spaces between the sides of the structure and the plate of the loading
surface. When the machine is moving and the operator is in front of it and activating the control lever,
he must watch out that no one else approaches the machine while it is in operation.
Figure 24
Risk of accidentally getting fingers stuck in the slits on the cut bread unloading surface, Figure 25,
and in the spaces described above. If this should happen, an unusual or impulsive movement of the
hand could result in painful pulling/twisting and even fracture of the fingers.
All the residual risks described here, although very
low, can be reduced further still if:
- the Employer supplies adequate information,
instruction and training on the correct, safe use of the
machine to the operators appointed, based on specific
work procedures, which must be observed with total
respect.
- the operator respects scrupulously the indications given
to him by his Employer, maintaining high levels of
concentration on the work that he is carrying out, and
avoids erroneous movements and/or actions.
NEVER PUT YOUR HAND IN
THESE SPACES!
NEVER PUT YOUR HANDS IN
THIS SLOT!
Figure 25
DO NOT INSERT YOUR FINGERS IN
THESE SLITS!
To Next Page
Loading...