Bread slicer C42 – C42S – C52 – C52S – G42
(Original instructions) – Edit. 02/2013 – Rev.A
1.2
INSTRUCTIONS AND GENERAL WARNINGS
The manufacturer cannot be held liable for any injuries and/or accidents to people, animals or damage
to property caused by the failure to observe the instructions given in this manual and in particular by
the failure to respect the following indications:
- Do not tamper with the guards and safety devices provided on the machine;
- Do not remove the guards or deactivate the safety devices provided on the machine;
- Replace the guards and reactivate the safety devices as soon as the reasons have ceased for which
it may have been necessary to remove/deactivate them temporarily;
- Do not use the machine for uses and/or loads different from those indicated by the manufacturer;
- Perform daily checks of the safety devices, the levels and the state of the technological fluids, if
present, and the general condition of the machine;
- Perform scrupulous and adequate daily cleaning;
- When performing adjustment, cleaning and maintenance, etc., take suitable precautions to ensure
that the machine or its parts cannot be started up by other persons, even accidentally.
- On the workplace, observe the European Directives and the laws and regulations of the
country in which the machine is installed and operating.
- Respect the limits of the climate conditions (see Table 1, Par. 2.4) and the allowed limits of use.
- On the sites where the machine is at work, the employer must provide employees with adequate
information and training concerning their specific tasks (in a simple and comprehensible form that
takes into account the level of understanding that can reasonably be expected of the receiver), with
relation to its correct and safe use and the general and specific risks of the workplace and/or job; to
fulfil such a delicate task this manual may provide a valid support, though it cannot be considered to
cover all subjects apart from those strictly related to the machine itself.
- The clothes worn by the operator must be close fitting with no loose, flapping parts; he/she must
not wear unbuttoned shirts, jackets or coats, etc., nor any jewellery (bracelets, necklaces, etc.) that
could get caught on projecting parts.
- Should replacement of one or more parts be necessary, use only original spare parts, ordering
them from the manufacturer. If non-original spare parts are used, the Manufacturer of the machine
considers itself relieved from any liability for damage to persons, things and/or animals that may
result as a consequence.
- Any single, arbitrary modification made to the machine relieves the Manufacturer from all
liability that might result from damage to persons, animals and/or things.
1.3
MAIN SITUATIONS WHEN THE COMPANY DOES NOT ACCEPT
LIABILITY
The manufacturer accepts no responsibility for damage to persons, animals and things, or loss of
production, under the following circumstances:
• machine used in a way that does not comply with its intended use, or for products different from
those specifically indicated in this manual
• installation not carried out in compliance with the procedures described in this manual
• use of the machine by persons who are not sufficiently educated or, if foreseen, not adequately
trained in its correct and safe use
• use of energy supplies that are different from or incompatible with those foreseen by the data
specifications in this manual
• lack of or scarce maintenance, or performing it without observing the methods indicated here
• non-observance, or partial observance, of the instructions provided in this manual
• arbitrary modification of the features and original equipment provided with the machine, without
receiving formal authorization from the Manufacturer
To Next Page
Loading...