42
The projector provides fan control function in the “Setup” menu. Select the operating
speed of the cooling fan according to the following altitude status of the projector.
High altitude
This function allows you to change the screen brightness.
Standard .......... Normal brightness.
ECO1
Low brightness, reducing power consumption, thus extending laser life.
Laser mode
ECO2
Lower brightness, reducing power consumption, thus extending laser life.
..........
..........
The operating time of the cooling fan after the projector is turned off.
Rapid cooling
Standard
After the shutdown, the fan stops operating after running for a long time...........
10 seconds After the shutdown, the fan stops operating after 10 seconds...........
0 second
After the shutdown, the fan stops operating after 0 second...........
Off . Normal speed. When using the projector, set this function to “Off”
if the altitude of the surrounding environment is not high.
..........
Highland 1
Faster than the “Off” mode. When using this projector at high
altitudes (600m – 1,300m), the fan cooling effect is reduced.
Select this mode.
..........
Highland 2
Faster than the “Highland 1” mode. When using this projector
at higher altitudes (1,300m – 2,500m), the fan cooling effect is
even weaker. Select this mode.
..........
To Next Page
Loading...
