Important safety tips!
10
Do not stack multiple projectors.
●Do not use the projector with the top as the support.
●Do not block the projector's ventilation openings (air intake and exhaust ports).
●Avoid blowing hot and cold air from the air conditioning system directly to the ventilation
openings (air intake and exhaust ports) of the projector.
●Do not install the projector in a confined space.
If the projector must be installed in a confined space, air conditioning or ventilation should
be installed separately. Accumulated waste heat may trigger the projector's protective
circuit when ventilation is poor.
●The company shall not bear any responsibility for any damage to the product due to
improper selection of the installation site, even if it is within the effective warranty period.
Safety
When using this product, take safety measures for the following events.
●Personal information being leaked via this product.
●Unauthorized operation of this product by a malicious third party.
●Interfering or stopping of this product by a malicious third party.
●Take adequate security measures.
●Try to set a password that is difficult to guess.
●Change the password regularly.
●The company and its affiliates do not directly inquire customers about passwords. Do not
say the password when receiving such information.
●The connecting network must be secured by a firewall or other software.
●Set a password for network control and place restrictions on the users who can log in.
Disposal
When discarding the product, please contact your local authorities or distributor and ask
for the correct product disposal method. In addition, do not disassemble this product when
discarding it.
Storage
Store the projector in a dry room.
Precautions for use
●In order to get the picture quality
When you create a suitable environment, you can see excellent pictures with higher contrast
ratio. Pull down the curtains or blinds and turn off any lights near the screen to prevent outside
light or light from indoor lamps from shining onto the screen.
●Do not touch the surface of the projector lens with you bare hand.
If the surface of the projector lens becomes dirty from fingerprints or anything else, this will
be magnified and projected onto the screen.
●LCD panel
LCD panels are precision-made, but in rare cases, pixels could be missing or always lit.
To Next Page
Loading...
