Ronan Engineering X96S User Manual

11
Calibration
State [status]
Ref Constants
Ref Constants
Cal Density
Cal Flow Rate
Ref Mode [mode] Ref Mode
Temp Reference
Calibr.Mode [mode]
[Select]
Cal Remote Solids
Ref Time [seconds] Empty
Last Ref Date [date] MinRefCnts [counts] Water
Last Ref. Time [time] MaxRefCnts [counts] Process
Loop Config
Absorber
Aux Loop Cfg
Cal Density
Calibr Mode
State [status] [Select]
Low Reference
Process
High Calibrate
Absorber
Manual Entry [number]
Clear Ref/Cal
Low Reference
Cal Flow Rate
Perform Reference
Ref Density [value units]
State [status] Ref Cap [read only]
Low Reference
High Calibrate High Calibrate
Manual Entry
Clear Ref/Cal Calibrate
Ref/Cal Time [s] Cal Density [value units]
Flow Rate [value] Cal Cap [read only]
Deviation 1/uT [read only]
Temp Reference Manual Entry
Temp LoRef 1/uT [multiplier]
Temp High Cal
Temp Cal Low [read only]
Low Reference
Temp Cal High [read only]
Temp Cap Low [read only] Low Flow Rate Cal
Temp Cap Hi [read only] Low Flow Rate [value units]
RTD Slope [value] Ref.Capt.Value [read only]
RTD Offset [value]
High Calibrate
Cal Remote Solids
High Flow Rate Cal
Lo Solids Cap [read only] High Flow Rate [value units]
Hi Solids Cap [read only] Cal. Captured Value [cnts]
Min Solids [value] Pulse Factor [read only]
Max Solids [value]
Low Reference
Manual Entry
High Calibrate
Pulse Factor [multiplier]
Loop Config
Fixed Flow Rate [value]
PV is [variable]
PV/SV/TV
Loop test [Select]
Damping [number] Mass Flow
D/A trim Density
Flow Rate
Aux Loop Cfg
Proc Temp
Head Temp
SV is [var]
Not Assigned
Aux 1 Test
Aux 1 Trim
PV/SV/TV Test
TV is [var]
[Select]
Aux 2 Test
4 mA
Aux 2 Trim 20 mA
Other
End
Figure 3-4 Calibration Menu

Ronan Engineering X96S Specifications

General

Brand	Ronan Engineering
Model	X96S
Category	Measuring Instruments
Language	English