Rosco Maximizer 3B User Manual

6-48 Rosco Maximizer 3B Asphalt Distributor
Operation
Combating Poor Visibility
Increasingly, asphalt maintenance equipment is being
used during less than ideal light conditions, such as fog,
smog and at night. Using the equipment during these
conditions presents safety hazards to the workers,
bystanders and passing trafc. People can be injured
or killed by the equipment, passing trafc or distractions
caused by road work.
If you will be operating the machine
under less than ideal light conditions, the unit should
be equipped with special lighting. Such lighting
will help prevent serious personal injury, as well as
damage to machine and property.
To help combat these hazards, the equipment must
be equipped with front and rear lighting options, back
up lights and shielded rotating beacons. The shielding
protects the operator’s vision and prevents eye strain.
Use reective tape on the sides of all machines that may
be used at night.
Be sure that all personnel wear reective vests. Use
impact barriers (movable or stationary) to protect the
workers from trafc and help direct the trafc ow away
from road hazards.
Washdown
It is extremely important that the components, lights,
reectors and safety decals on the Maximizer 3B are
kept clean and visible.
Rosco recommends the use of biodegradable cleaning
solvents (Figure 6-31).
Fire Hazard! Never spray cleaning
solvent or release agent near a heating element or
near any open ame or source of ignition. Do not
operate Burner System during cleaning! Cleaning
solvent and release agent could ignite causing
serious personal injury.
When using washhdown, consider the
environment and do not allow cleaning solvent to run
onto the ground.
Return to
Last Viewed
Return to
Thumb Index

Rosco Maximizer 3B Specifications

General

Brand	Rosco
Model	Maximizer 3B
Category	Utility Vehicle
Language	English