EasyManuals Logo

Rosco Maximizer 3B User Manual

Rosco Maximizer 3B
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
6
Rosco Maximizer 3B Asphalt Distributor 6-25
Operation
2. Set the Plus One Controller Auto/Manual selection
to MANUAL.
3. Set the Plus One Controller Pump Control priority to
FRONT.
4. Set the Plus One Controller Mode Selection control
to TANK CRCLT.
5. Turn Manual Pump Speed dial in FORWARD
direction and run pump at 50 - 75 GPM to circulate
the asphalt.
Tank Circulate Mode
When heating and transporting material, run the
Maximizer 3B in TANK CRCLT in order to mix and
distribute the material in the tank and to minimize the
loss of heat from the plumbing (Figure 6-17).
Never operate burner when the vehicle
is being loaded or in transit. The ue tubes can
become exposed, causing an explosion inside the
tank, or material being sprayed could ignite.
1. Turn the Plus One Controller Master switch ON to
activate the system, (Figure 5-2,1).
Return to
Last Viewed
Return to
Thumb Index

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rosco Maximizer 3B and is the answer not in the manual?

Rosco Maximizer 3B Specifications

General IconGeneral
BrandRosco
ModelMaximizer 3B
CategoryUtility Vehicle
LanguageEnglish