Rosco Maximizer 3B User Manual

6
Rosco Maximizer 3B Asphalt Distributor 6-43
Operation
To prevent the material from setting up in the tank,
monitor the solvent in the tank by removing the ll
cap and checking the uid in the tank with a ashlight.
Remove and replace the solvent before it becomes too
thick to remove. This will require a container of at least
25 gallons.
Avoid contaminating the environment while draining the
solvent. Dispose of material according to local, state and
federal regulations. If the material becomes set, heat the
Enviroush tank with steam until the material becomes
uid enough to drain.
DO NOT SMOKE around the machine.
Fuel, asphalt material and the fumes from both
can explode when exposed to ame or heat from
smoking or other sources.
Beware of hot material in lines. Always
wear protective clothing, gloves and a face shield.
Contact with hot asphalt can cause severe burns.
Clean-out Mode
Follow this procedure when ushing the spraybar and
plumbing circuit using the Enviroush System, (see
Automated Clean-out Mode in Section 6).
Do not use Terpene Hydrocarbon or
equivalent to clean out the spraybar. It destroys the
Viton seals.
1. After the automated clean-out process drain
Enviroush tank as necessary and dispose of
solvent in accordance with local, state and federal
regulations.
Depending on the type of asphalt
materials being used, the solvent in the Enviroush
tank can be used multiple times to clean the
spraybar and pumping circuit. However, if the
solvent is used too many times, the concentration
of asphalt material in the tank may become so high
that it will set up. This makes the tank unusable and
the material is difcult to remove. The same problem
will occur if the spraybar is full of asphalt and this
asphalt is pumped into the Enviroush tank.
Return to
Last Viewed
Return to
Thumb Index

Rosco Maximizer 3B Specifications

General

Brand	Rosco
Model	Maximizer 3B
Category	Utility Vehicle
Language	English