Rosco Maximizer 3B User Manual

7-14 Rosco Maximizer 3B Asphalt Distributor
Maintenance
LPG Burners (Option)
The LPG Burners are located at the rear of the
Maximizer 3B. Check the burner operation daily. Follow
this procedure:
DO NOT SMOKE around the machine.
Fuel, asphalt material and the fumes from either
can explode when exposed to ame or heat from
smoking or other sources.
Always wear protective clothing,
gloves and a face shield. Burners are hot and contact
with skin can cause severe injury.
1. Visually inspect the burner and mounting system
daily. Tighten, repair or replace components as
required.
2. Check the fuel level in the tanks daily.
3. Check the valves and fuel lines before the burners
are lit. If a leak is suspected, use soapy water to
identify the source of the leak.
4. Use a wrench to tighten the burner mounting
hardware before using the burners.
5. Visually inspect the ue liners and ue tubes for
cracks or other damage.
Never operate burners if ue tubes
are damaged. Asphalt material coming through the
cracked tube could ignite when the burner is lit.
Consult your Rosco dealer for repair procedures.
Burner System
Diesel Burners
The diesel burners are located at the rear of the
Maximizer 3B. Check the burner operation daily. Follow
this procedure:
DO NOT SMOKE around the machine.
Fuel, asphalt material and the fumes from either
can explode when exposed to ame or heat from
smoking or other sources.
Always wear protective clothing,
gloves and a face shield. Burners are hot and contact
with skin can cause severe injury.
1. Excessive smoke or trouble starting means burner
cover must be removed for cleaning or adjustment.
Visually inspect the burner and mounting system
daily. Tighten, repair or replace components as
required.
2. Check fuel level in the tanks on a daily basis. Add
fuel as required.
3. Check the fuel lter and fuel lines before the burners
are ignited. Tighten ttings that are leaking and
replace any damaged parts. Clean lter as required.
4. On a monthly basis or every 80 hours remove
burner covers and check condition of burner. Clean
asphalt build-up from burner components.
5. On a monthly basis or every 80 hours remove
burner from tank and check the condition of the ue
liners and ue tubes. Replace liner if damaged and
inspect ue tubes for damage.
Never operate burners if ue tubes
are damaged. Asphalt material coming through the
cracked tube could ignite when the burner is lit.
Consult your Rosco dealer for repair procedures.
Return to
Last Viewed
Return to
Thumb Index

Rosco Maximizer 3B Specifications

General

Brand	Rosco
Model	Maximizer 3B
Category	Utility Vehicle
Language	English