EasyManuals Logo

Rosco Maximizer 3B User Manual

Rosco Maximizer 3B
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
2
Rosco Maximizer 3B Asphalt Distributor 2-5
Safety
Flying Object Hazard
Always wear eye protection when cleaning
the Rosco Maximizer 3B Asphalt Distributor
with compressed air or high-pressure
water. Dust, ying debris, compressed air,
pressurized water or steam may injure your
eyes.
Coolant Hazard
Wear eye protection and rubber gloves
when handling engine coolant. If contact
with the eyes or skin should occur, ush
eyes and wash immediately with clean
water.
Burn Hazard
Some of the machine surfaces become
very hot during operation and shortly after
shutdown.
• Keep hands and other body parts away from hot
machine surfaces.
• Handle hot components with heat-resistant gloves.
The safety messages that follow have CAUTION level
hazards.
Poor Lighting Hazard
Ensure that the work area is adequately illuminated.
Always install wire cages on portable safety lights.
Tool Hazard
Always use tools appropriate for the task at hand and
use the correct size tool for loosening or tightening
Rosco Maximizer 3B Asphalt Distributor parts.
The safety messages that follow have NOTICE level
hazards.
Any part which is found defective as a result of
inspection or any part whose measured value does not
satisfy the standard or limit must be replaced.
Always tighten components to the speciî›™ed torque.
Loose parts can cause Rosco Maximizer 3B Asphalt
Distributor damage or cause it to operate improperly.
Only use replacement parts approved by LeeBoy. Other
replacement parts may affect warranty coverage.
Follow the guidelines of the EPA or other
governmental agencies for the proper
disposal of hazardous materials such as
engine oil, diesel fuel and engine coolant.
Consult local authorities or reclamation
facility.
• Clean all accumulated dirt and debris away from
the body of the machine and its components before
you inspect the machine or perform preventive
maintenance procedures or repairs. Operating
a machine with accumulated dirt and debris will
cause premature wear of machine components.
Accumulated dirt and debris also hinders effective
machine inspection.
• Retrieve any tools or parts that may have dropped
inside of the machine to avoid improper machine
operation.
• Dispose of hazardous materials in accordance with
all applicable laws and regulations. Never dispose of
hazardous materials by dumping them into a sewer, on
the ground, or into groundwater or waterways.
• If any alert indicator illuminates during machine
operation, stop the engine immediately. Determine
the cause and repair the problem before continuing to
operate the machine.
Return to
Last Viewed
Return to
Thumb Index

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rosco Maximizer 3B and is the answer not in the manual?

Rosco Maximizer 3B Specifications

General IconGeneral
BrandRosco
ModelMaximizer 3B
CategoryUtility Vehicle
LanguageEnglish