June 2016
12
Quick Start Guide
5.0 Product Certifications
Rev 1.2
5.1 Telecommunication compliance
All wireless devices require certification to ensure that they adhere to regulations
regarding the use of the RF spectrum. Nearly every country requires this type of
product certification. Emerson is working with governmental agencies around
the world to supply fully compliant products and remove the risk of violating
country directives or laws governing wireless device usage.
5.2 FCC and IC
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions: This device may not cause harmful interference. This device
must accept any interference received, including interference that may cause
undesired operation. This device must be installed to ensure a minimum antenna
separation distance of 20 cm from all persons.
5.3 European Directive Information
A copy of the EC Declaration of Conformity can be found at the end of the Quick
Start Guide. The most recent revision of the EC Declaration of Conformity can be
found at EmersonProcess.com/Rosemount.
5.4 Ordinary Location Certification
As standard, the transmitter has been examined and tested to determine that the
design meets basic electrical, mechanical, and fire protection requirements by a
nationally recognized testing laboratory (NRTL), as accredited by the Federal
Occupational Safety and Health Administration (OSHA).
5.5 Installing Equipment in North America
The US National Electrical Code
®
(NEC) and the Canadian Electrical Code (CEC)
permit the use of Division marked equipment in Zones and Zone marked
equipment in Divisions. The markings must be suitable for the area classification,
gas, and temperature class. This information is clearly defined in the respective
codes.
USA
I5 FM Intrinsically Safe
Certificate: 3034378
Standards: FM Class 3600:1998, FM Class 3610:2010, FM Class 3810:2005,
NEMA
®
-250:1997, ANSI/ISA-60079-0:2009, ANSI/ISA-60079-11:2009, IEC
60529:2004
Markings: IS CL I, DIV 1, GP A, B, C, D; NI CL I, DIV 2, GP A, B, C, D; IS CL I, Zone 0, AEx ia
llC T4 (–50 °C ≤ T
a
≤ +70 °C), when installed per Rosemount drawing
00849-1000; Type 4X; IP66
See Tab le 2 at the end of the Product Certifications section for entity parameters.
To Next Page
Loading...
