To Next PageTo Next Page
Need help?Do you have a question about the Rosemount 8732E and is the answer not in the manual?
General| Type | Magnetic Flowmeter Transmitter |
|---|---|
| Category | Flow Measurement |
| Manufacturer | Emerson |
| Enclosure | Aluminum or Stainless Steel |
| Communication Protocols | HART, FOUNDATION Fieldbus |
| Power Supply | 12-42 VDC |
| Enclosure Rating | NEMA 4X, IP66/IP67 |
| Display | Backlit LCD |
| Product Type | Transmitter |
| Diagnostics | Advanced Diagnostics |
| Input | Flow sensor input |
| Output | HART, FOUNDATION Fieldbus |
| Hazardous Area Approvals | ATEX, IECEx, FM, CSA |
| Measurement Type | Volumetric flow |
| Output Signal | 4-20 mA |
| Process Connection | Flanged, wafer, or sanitary |
| Electrode Material | 316L stainless steel, Hastelloy C, titanium, tantalum |
| Liner Material | PTFE, PFA, Polyurethane |
Details on mounting site requirements for the transmitter, ensuring adequate space and access.
Specifies minimum straight pipe diameters required upstream and downstream of the sensor.
Instructions on orienting the sensor to point in the direction of flow.
Details on gasket selection, flange bolt tightening sequence, and torque values for flanged sensors.
Guidelines for installing wafer sensors, including gasket, alignment spacer, and stud specifications.
Information on gaskets and alignment/bolting procedures for sanitary sensor installations.
Table and figures detailing grounding methods based on pipe type and grounding options.
Covers conduit entries, cable types, and preparation for electrical connections.
Details on remote mount cable lengths, preparation, and shielding for transmitter-sensor connections.
Information on fieldbus connection wiring, power supply requirements, and cable specifications.
Explains power supply types (AC/DC), wire requirements, disconnects, and overcurrent protection.
Overview of initial transmitter configuration, including engineering units and sensor size.
How to assign or change the device tag and network address using a configuration tool.
Configuring Analog Input (AI) and Transducer blocks for flow measurement parameters.
Details on EC conformity, CE marking, and essential health and safety requirements.
Information on international certifications like IEC and C-Tick marking for product compliance.
