Quick Start Guide
3
June 2016
1.0 Wireless considerations
1.1 Power up sequence
The power module should not be installed on any wireless device until the
Emerson
™
Smart Wireless Gateway (Gateway) is installed and functioning
properly. Wireless devices should also be powered up in order of proximity from
the Gateway, beginning with the closest. This will result in a simpler and faster
network installation. Enable Active Advertising on the Gateway to ensure that
new devices join the network faster. For more information see the Smart Wireless
Gateway Reference Manual.
1.2 Antenna position
The antenna should be positioned vertically and it should be approximately 3 ft.
(1 m) from any large structure, building, or conductive surface to allow for clear
communication to other devices.
Figure 1. Antenna Position
1.3 Conduit plug
The temporary orange plugs should be replaced with the included conduit plugs
using approved thread sealant.
To Next Page
Loading...
