Ross ULTRIX-FR12 - Cabling for UltriScape Heads

ULTRIX-FR12 Installation Guide (v4.0) Cabling Your Router • 35
To connect the video reference source to the ULTRIX-FR12
1. Connect a valid reference signal to either BNC in the BNC pair labeled REF A.
2. Select either TERM or LOOP on the DIP switch A to select the preferred BNC mode.
Figure 6 ULTRIX-FR12 — DIP Switch in the TERM Positions
Cabling for an UltriScape Head
The number of UltriScape (Multiviewer) Heads for your ULTRIX-FR12 router depends on the number
of UltriScape licenses enabled and the total number slots populated with I/O blades. Table 7 lists
the connections on the rear panel that are available for UltriScape Heads based on the type of
blade installed in the slot.
Table 7 Outputs Allocated for UltriScape Heads
Blade Model Slot Head 1 Head 2 Head 3
Ultrix HDX-IO Slot # AUX A or OUT 1 AUX B or OUT 5 OUT 13
ULTRIX-IP-IO Slot # AUX 1 AUX 2 --
ULTRIX-IPX-IO Slot # AUX A AUX B --
ULTRIX-SFP-IO Slot # AUX A or SFP 1 SFP 5 or SFP 7 SFP 11 or SFP 13
14
SFP 1 SFP 2
LOOP
TERM
A B
1 9 10111213141516
IN
5678324
9 10111213141516
IN
5678324
9 10111213141516
IN
5678324
9 10111213141516
IN
5678324
9 10111213141516
IN
5678324
9 10111213141516
IN
5678324
9 10111213141516
IN
56783214
9 10111213141516
IN
5678324
16
9 10111213141516
IN
5 67832 4
16
9 10111213141516
IN
5 67832 4
516
9 10111213141516
IN
5 67832 4
15 16
9 10111213141516
IN
5 67832 4
15 16
9 10111213141516
IN
5678324
15 16
9 10111213141516
IN
5678324
15 16
9 10111213141516
IN
5678324
15 16
9 10111213141516
IN
5678324
1 1 1 1 1 1 1 1 1
REF A
LOOP
TERM
A B
DIP SWITCH A