AY-B9350 User Manual 30
3.3.1.7. Authentication Option
▶ ’Fingerprint verification level’ (Default setting: ‘0’)
This item is to decide fingerprint verification level for
each user. Authentication level for each registered user
can be changed by change this value.
If it is set to ‘0’, authentication will be done using 1 to 1
fingerprint verification level at the terminal.
▶
If ‘Allow 1 to N face identification (Default setting: face
is registered [v])’ option is checked, authentication with
only face without user ID or card is possible.
3.3.1.8. Authentication Method
Press [Auth Type] button in [Add user] screen to set
authentication method. (However, this can be set only
when more than one authentication method are
registered.)
To move out witho ut changin g, press [BACK] button.
“▶ registered authentication method” in the left screen
shows all already registered authentication methods. If
each authentication method is selected, it will be deleted
from authentication method.
The buttons below display combination of authentication
method which can be selected. Press the button desired
to be changed to change authentication method to move
to the previous screen.
The followings are icons for authentication method.
: fingerprint : face
: card : password
To Next Page
Loading...
