Keypad Programming Instructions (AY-Q6350)
28 AY-Q6x50 Family Installation and Programming Manual
You hear three beeps.
The system returns to Transmit mode.
• The Default Programming code is 1234
• Programming code cannot be erased, meaning the code 0000 is
not valid and does not erase the Programming code
5.11 Changing the Facility Code
To change the Facility code:
1. Enter Programming mode.
2. Press 4 to enter Menu 4.
The Transmit LED turns red.
3. Enter the new 3-digit code you wish to
set as the Facility code.
You hear three beeps.
The system returns to Transmit mode.
• The default Facility code is 001.
•
Facility codes can be in the range between 000 and 255.
5.12 Setting the Backlight
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The Transmit LED turns red.
To Next Page
Loading...
