Keypad Programming Instructions (AY-Q6350)
AY-Q6x50 Family Installation and Programming Manual 17
5.4 Entering Programming Mode
To enter Programming mode:
1. Press # 4 times.
The Transmit LED turns off and the
Program LED turns red.
2. Enter your Programming code.
3. If the Programming code is valid, the
program LED turns green and the AY-
Q6350
enters Programming mode.
• The factory default Programming code is 1234.
• If a Programming code is not entered within 30 seconds, the AY-
Q6350
returns to Transmit mode.
5.5 Exiting Programming Mode
To exit Programming mode:
1. Press #.
You hear a long beep.
The Transmit LED turns red and the
Program LED turns off.
This indicates that the AY-Q6350
has returned to Transmit mode.
While in Programming mode, if no key is pressed for 30 seconds,
the AY-Q6350
exits Programming mode and returns to Transmit
mode.
To Next Page
Loading...
Need help?
General
