6.9.2. Entering Programming Mode
1) Press the # key twice within 2 seconds.
• Mode LED will turn off.
• Door LED will turn red.
2) Enter your Programming Code
• Door LED will turn green
Note:
• The AYC-Fx4/AYC-Gx4 must be in Normal Mode to enter the
Programming mode.
• The factory four digit Programming Code is 1234.
• If a Programming Code is not entered within five seconds,
6.9.3. Exiting Programming Mode
1) Press the “#” key two times
within 2 seconds
• You will hear 3 beeps.
• The Door LED will turn off
and the Mode LED will
return to Normal.
2) Wrong entries may reset the controller back to Normal mode.
3) While in Programming mode, if no key is pressed for one
minute the AYC-Fx4/AYC-Gx4 will exit Programming mode
and return to Normal mode.
6.9.4. Changing Lock Strike Code
The Lock Strike Code is mainly used as a method to quickly test
the Lock Strike Relay during installation.
When the first user is added to the controller, the default Lock
Strike Code will automatically be deleted. Once the code is
programmed again, it will not be deleted with the entry of
additional User Codes.
1) Enter Programming mode.
To Next Page
Loading...
Need help?
General
