Controller Functionality
AYC-Fx4 and AYC-Gx4 family manual Page 53
6.9.18. Pin Code Length / Factory Default Settings
• You must be very careful before using this command!
Changing the pin code length will also erase the entire
memory contents, including all user and special codes, and
return all codes to their factory-default settings
1) Enter the Programming
Mode.
2) Select the desired pin code length as follows:
a. 00 – Returns to factory defaults and sets a 4 digit code.
b. 05 - Returns to factory defaults and sets a 5 digit code.
c. 06 - Returns to factory defaults and sets a 6 digit code.
d. 08 - Returns to factory defaults and sets a 4-8 digit code.
When choosing the 4-8 option, please note that you should
either enter zeros before the code, or press pound at the end
(for example if your code is 12345, enter either 00012345 or
• Both the Mode and Door
LEDs will flash red.
3) Enter your 4-8 digits Programming
Code.
• If the Programming Code is valid, all memory will be erased.
You will hear three beeps and the controller will return to
Normal Mode.
• If the Programming Code is invalid you will hear a long
beep and the controller will return to Normal Mode without
erasing the memory contents.
To Next Page
Loading...
Need help?
General
