Keypad Programming Instructions
AY-T6350 Installation and Programming Manual 27
5.8 Return to Factory Default Settings
You must be very careful before using this command! Doing so
erases the entire memory that includes all user and special
codes, and returns all codes to their factory default settings.
To return to factory default settings:
1. Enter Programming mode.
2. Press 0 to enter Menu 0.
The LED flashes green.
3. Enter your Programming code.
If the Programming code is valid, all memory is erased. You hear
three beeps and the controller returns to Transmit mode.
If the Programming code is invalid you hear a long beep and the
controller returns to Transmit mode without erasing the memory
of the controller.
5.9 Replacing a lost Programming Code
In the event that the Programming code is forgotten, the unit may be
reprogrammed in the field using the following instructions:
1. Remove power from the reader.
2. Activate tamper by removing the reader from the wall or
removing the reader's case.
3. Apply power to the reader.
4. You now have 10 seconds to enter Programming mode using the
factory default Programming code 1234.
To Next Page
Loading...
Need help?
General
