Rotary SPO55E - 4.7 Unloading; 4.8 Power Off; 5. Problems, causes, actions; 5.1 Troubleshooting by the operator

4.7 Unloading:
• Remove adapters from under vehicle and swing
arms to full drive-thru position before moving vehicle.
• Assure Exit area is clear of objects and personnel
before removing vehicle from lift.
4.8 Power Off:
• Turn E-Stop switch to "OFF" position while lift is not
in use.if need ,lock the switch with a padlock.
9
Front
Lift Points
Front
Front
Front
Lift Points
Lift Points
Lift Points
Unitized Body
Stub Frame
Perimeter Frame
Pickup Truck
Typical Lift Points
Fig.15
WARNING
Most specialty or modied vehicles can-
not be raised on a frame engaging lift.
Contact vehicle manufacturer for raising
or jacking details.
5. Problems, causes, actions
The following lists contain information on pote-
ntial problems,their causes, and actions to rect-
ify the fault.
Repairs to safety mechanisms on the lift
may richtungen only be carried out by
authorized maintenance contractors
(component persons).
During a breakdown (power failure), the lift
remains automatically in safe mode. This
means that all movement is halted.
If the lift is out of order for long periods,
carry out the following steps:
1. Lower the lift to the lowest position.
2. Switch the main switch to
Off and lock with a padlock.
3. Disconnect the power supply.
5.1 Troubleshooting by the operator
The following troubleshooting measures may
only be carried out by an authorized operator.
Before doing so, make sure that power supply
is connected, the main switch is in the "ON“position.
If thethe problem is not rectied by the listed
measures,you must seek advice from a
competent person.
The troubleshooting measures listed in 5.2
may only be carried out by maintenance
contractors.
i
i
i
i
19