Fig.19
10. Transport, Storage
Crushing and shearing hazard
for limbs when unloading.
Caused by collapsing or slipping
of the load.
Only unload the packing unit and trans
port to the installation site with a forklift
truck or pallet jack with a sufcient
load capacity.
Only use hoists approved for the total
weight (straps, chains etc.).
Attach these so that the load cannot
slip(check the center of gravity of the
load).
Only secure individual components to
loadbearing parts. Always lift vertically,
steadily and without jerking.
Carry out a visual inspection before
ofoading.
Do not stand close to or underneath
swinging loads.
Constantly monitor the danger zone
when lifting or lowering.
Always transport hydraulic compo
nents empty of oil.
Lift components may be damaged
if ofoaded incorrectly.
Do not damage plates on the underside of
the lift when lifting.
Several parts are inserted into the compo
nents,for example into the columns. Off
load these carefully to prevent damage.
When ofoading, proceed from top to bot
tom.
35
A
B
C
D
71 .giF
Replace cables/cable sheaves
• Damaged cables must be replaced promptly.
• If cables / cable sheaves are damaged, inform
maintenance contractors and customer service
immediately.
• Always replace all cables together as a set.
• If the cable is too slack → Chapter 12.
Commissioning.
• Replace cables as per the manufacturers training.
To Next Page
Loading...
