INITIAL SETUP AND PROGRAMMING SUMMARY
Operation of the Register
1 Initial Start up
A Be sure that the register
is
on a hard level surface
B Connect the power cord to an AC three
wire
outlet
CAUTION It
is
not recommended to plug the register
into
an outlet
with
any other appliances
C Install ribbon (as necessary)
D Install paper roll (as necessary)
E Replace Journal Cover
A Turn Control Lock key to
"PGM-1"
position
Step 1 Enter Tax Option
Step
2 Enter
time
date and periodic total printing option
Step 3 Enter transaction number and grand total print option
Step 4 Press [AMOUNT
TEND/TOTAL]
key to enter program and for tape readout
B Turn Control Lock key to
"PGM-2"
position
Step 1 Enter the department function option
Step
2 Enter discount rate press
[-%j
key
Step 3 Enter digit lock out number press [RETD MDSE] key
Step 4 Enter register number Press [VOID] key
StepS
Enter date Press [CH] key
Step6 Enter correct
time
Press [X] key
Step 7 Enter Tax 2 fixed percentage tax rate press [R/A] key Enter Tax 1 fixed percentage tax rate or state table tax rate
press [P/O] key
Step 8 Press [AMOUNT
TEND/TOTAL]
key to enter program and for tape readout
3 Operating Register
A Turn control lock key to
"R"
position
THE ER
145
IS NOW READY FOR USE
To Next Page
