Publication date: Jan., 2009
Revision A1
120
Port Mode Port Control Authentication Port Status
Disable Don’t Care Don’t Care Port Uncontrolled
Multihost Auto Successful Port Authorized
Multihost Auto Failure Port Unauthorized
Multihost ForceUnauthorized Don’t Care Port Unauthorized
Multihost ForceAuthorized Don’t Care Port Authorized
Table 3-3
Function name:
802.1x State Setting
Function description:
This function is used to configure the global parameters for RADIUS
authentication in 802.1x port security application.
Fig. 3-66
Parameter description:
Radius Server:
RADIUS server IP address for authentication.
Default: 192.168.1.1
Port Number:
The port number to communicate with RADIUS server for the
authentication service. The valid value ranges 1-65535.
Default port number is 1812.
Secret Key:
The secret key between authentication server and authenticator. It is a
string with the length 1 – 31 characters. The character string may contain
upper case, lower case and 0-9. It is character sense. It is not allowed for
putting a blank between any two characters.
Default: Radius
To Next Page
Loading...
Need help?
General
