RUPTELA FM Pro - Lastchange; SMS During Critical Process

R&D department
2018/08/01
“Calibration successful” - when calibration process was finished successfully.
1.1.26 lastchange
SMS message is used to know when was the last time device configuration or primary server IP changed.
Example: pass lastchange
If time is not synchronized, or changes occur during that time, SMS content will be:
Response example: lastchange ip: no time available; cfg: no time available
If time is available:
Response example: lastchange ip: 2015-11-09, 09:02; cfg: 2015-11-09, 10:02
Configuration change date and time will be updated during any type of configuration modification.
When device is connecting to GPRS and tries to open link (with different IP settings), IP change date and time will
be updated. When device reconnects to server with same IP but different Port, IP change date and time will not be
updated.
1.1.27 SMS during critical process
There are 4 critical processes:
• Firmware update
• Configuration update
• Tacho read
• Smart Card read
During these processes following SMS commands will be ignored:
• reset
• connect
• econnect
• switchip
• setconnection
• delrecords
• setcfg
• getcfg
• setioparam
• getioparam
• clear obd
• tacho
Response example: The device is busy with critical process. Please try again later.
19