R&D department
2018/08/01
1.1.42 clear dtc
This SMS command allows to clear J1939 and J1708 DTC codes from the memory of the FM device.
SMS command
SMS command structure: pass clear DTC
Responses
• If command was performed successfully, response will be: DTC codes were cleared
• If DTC reading is not configured, response will be: DTC reading is not configured
1.1.43 doutreset
This SMS command allows to reset the state of activated DOUTs. This command works in correlation with
the “DOUT activation with conditions” functionality, and requires it to be enabled and configured to work.
SMS command
SMS command structure: pass doutreset
Responses
• If command was performed successfully, response will be: DOUT activation mechanism was reset
• If DOUTs are not active at the time, response will be : DOUT activation mechanism is inactive
• If the “DOUT activation with conditions” functionality is not configured, response will be : DOUT activation is not
configured
1.1.44 immobilizer
This SMS command allows to immobilize the vehicle. This functionality works in correlation with the
“Immobilizer” functionality, described in the “DOUT activation with conditions” document. If the
“Immobilizer” mode is not configured, the command will not work.
SMS command
SMS command structure: pass immobilizer <speed>
<speed> - describes the vehicle speed at which the progressive DOUTs must be toggled.
Responses
• If command was performed successfully, response will be: Immobilizer OK
• If no custom DOUTs are configured, the device will respond with the following message: immobilizer is not
configured.
• If <speed> parameter was inputted incorrectly, only numbers from 1 to 250 can be sent, the response will be:
Invalid speed.
SMS command to reset functionality
SMS command structure: pass resetimmob
36
To Next Page
Loading...
