R&D department
2018/08/01
Responses:
• When device gets this command and log sending is in progress, it should stop sending log to server and reply
with SMS: stoplog ok
• If device gets this command and the log is not running, then the reply should be: getlog already stopped
Disclaimer: In some cases remote debug might have to log data about many different events and processes. This would
force remote debug to generate large internal data streams. Device might not be able to sent it all via GPRS. This might
lead to data loss.
1.1.40 info – get some specific information from the FM device via SMS
This customizable SMS command with configurable set of parameters can be used to get some specific
information from the FM device via SMS.
Parameter Description
time Current GMT date and time
coords
Current latitude and longitude separated by comma (,). Device will reply “GNSS data not
available” if there will be no GNSS fix
alt Current altitude
sat Currently visible satellites
dir Current angle
speed Current speed, km/h
hdop Current HDOP level
gps
Current GPS/GLONASS state: 1-off, 2-on no fix, 3-on got fix, 4-not responding, 5-sleep, 6-
disabled.
eng Current engine state: 0 – OFF, 1 – ON.
blver Bootloader version
fwver Firmware version
hwver Hardware version
st Date & time (GMT) from the last FM device rest/power ON.
gsmlvl GSM signal level
op GSM operator number
lac Location Area Code
cid GSM Cell ID
modi The number of times when FM device has tried to initialize modem since start time.
modr The number of modem resets since start time.
modsp The number of times when modem was turned ON and turned OFF unsuccessfully.
gprs Status of GPRS. There are two possible values: 0-no GPRS, 1-attached to GPRS.
gprso The number of opened GPRS sessions.
gprsc The number of closed GPRS sessions.
gprse The number of GPRS errors.
lko The number of opened links.
lke The number of link errors.
lktmo The number of server response timeout.
rs FM4 device last reset source. Possible causes:
04 - reset pin; 08 - power on/down reset; 10 - software reset; 20 - independent watchdog; 40 -
window watchdog; 80 - Low power reset.
33
To Next Page
Loading...
