R&D department
2018/08/01
Parameter Description
14 means 10 (software reset) + 04 (reset pin)
In other words FM device resets himself, for example after FW update.
p GPRS protocol version: 0 – standard protocol; 1 – extended protocol.
imei Device IMEI number
apn APN name
apnu APN username
apnp APN password
ip1 IP1 address and port number
ip2 IP2 address and port number
prot Currently set protocol: 0 - TCP or 1 - UDP.
modrev Used to get modem revision information.
tacho Current tachograph status information: 0 – Not available; 1 – everything is OK; 2 – tacho
parameters not configured; 3 – extender not responding; 4 – tacho task in progress; 5 – physical
connection OK, logical is not OK.
get3g Answer according to “get3g” SMS command description
gmap Hyperlink to Google maps with coordinates: latitude and longitude.
dout1
Is used to get status about Dout1, Dout2, Din1, Din2, Din3, Din4, Ain1 and Ain2. Values: 1 –
high, 0 – low. Analog inputs – millivolts.
Response will contain only values of requested parameters.
dout2
din1
din2
din3
din4
ain1
ain2
pwr Returns power supply voltage in millivolts.
bat Returns battery voltage in millivolts.
io[xxxxx]
Used to get specific IO current value. [xxxxx] contains IO ID number.
Only activated in configuration IO data can be retrieved.
For multi-part IO elements, first IO ID should be requested.
IO parameters that are being reset with record sending should not be available, response would
be NA.
Password, command and command text are separated by space symbol. If there is no password, then you need
to write just space symbol before the command. Command text parameters are separated by semicolon (;) symbol.
Response command text parameters are separated by semicolon (;) symbol. All content of SMS command is not case
sensitive.
SMS structure: pass info param1;param2;param3;[...];paramN
Example 1: pass info bat;alt;IO29;IO123;coords
Response example: 4075;213.9;11659;0x4C5455313233343536373839303132333400000000000000;54.7412916,25.22
27750
Example 2: pass info time;imei;eng;IO29
Answer: 2016-12-13 12:40:30;865789021340700;0;11691
Maximum length of a response is 160 symbols. If response is longer, then the device will send maximum 157
characters of response plus “#” symbol and two digits number that shows, which tag was last in the reply counting from
the beginning.
Example: pass info gmap;coords;IO123;pwr;st;time
34
To Next Page
Loading...
