R&D department
2018/08/01
• DIN# - negative mode;
• Configurable DIN functionality is not available for your HW version.
1.1.47 SMS forward
This SMS command allows to forward a SMS via the FM device.
SMS command
SMS command structure: pass forward <phone_number> <text>
<phone_number> - must not contain “0” or “+” in the beginning of the number (Not +370 or 00370,
but 370);
<text> - Supports only GSM 03.38 characters.
Total length of whole command with text may not exceed 160 symbols.
Responses
• SMS-Forward OK
• SMS-Forward Fail
1.1.48 snapshot
This SMS command allows taking pictures on demand via connected RS232 cameras.
SMS command
SMS command structure: pass snapshot <camera number>
<camera number> can have the following values:
• 0 – the command applies to all configured cameras;
• 1 – the command applies to the camera configured on PortA;
• 2 – the command applies to the camera configured on PortB.
Response structure: snapshot <camera number> <answer> , <other camera number> <answer>
<answer> can be one of the following:
• ok – indicates that the camera took a picture successfully;
• busy – indicates that the camera is busy with a previously taken picture at the moment;
• n/a – indicates that the camera is either not configured on the given port, not connected or not responding;
• full – indicates that the memory of the SD card is full and the oldest picture will be overwritten;
• fullsd – indicates that the memory of the SD card is full and the picture will be discarded, as there are no
pictures to be overwritten;
• err – indicates that there was an error.
Example 1: pass snapshot 1
Response: snapshot 1 ok
Example 2: pass snapshot 0
Response: snapshot 1 ok, 2 n/a
38
To Next Page
Loading...
