R&D department
2018/08/01
• If SMS configuration is disabled in configuration tool or configuration has password:
„You do not have permission to read the settings“
1.1.32 setvalue – set specific IO values
Purpose is to set specific IO values.
Parameter Pro4 family Eco4 family Plug4
Virtual odometer (ID:65) ● ● ●
Absolute idling time (ID:175) ● ● ●
CAN Bus Distance (ID:114)* ●
DIN1 hours accumulated (ID:577) ● ●
DIN2 hours accumulated (ID:578) ● ●
DIN3 hours accumulated (ID:579) ● ●
DIN4 hours accumulated (ID:580) ● ●
*Value will be overwritten by valid message from CAN-Bus (if available in specific vehicle).
In general SMS structure is: “(password) (command) (command text)”
In “command text” field there will be ID and its value separated by comma (,).
The response format depends on these options:
1. If IO value was changed successfully, then format is: ID,value
2. If FM device failed to change IO value, then format is: ID,fail
3. If the value change for specified IO is not supported, then format is: ID,unsupp
4. If the FM device is even failed to parse the ID or data is incorrect: Set IO value data incorrect
Example: pass setvalue 65,0 Response example: 65,0
Example: pass setvalue 175,0 Response example: 175,0
Example: pass setvalue 155,15 Response example: 155,unsupp
24
To Next Page
Loading...
